How we got the job done To obtain the data

How we got the job done To obtain the data that we needed to do this assignment we had to use several different besidesls or materials. To distinguish with you will need: String of different sizes, a ruler, I recommend a meter stick with centimeter measurements, abstruse loads not to large, a stopwatch, and a protractor to measure your premium. To write down out we got all of the materials that are needed. Next we tide our post train at the length of 92cm to the light fixture above. and then we added a 20g weight to the end which is the bob. Then we swung it from the amplitude of 50 degrees recording how many an(prenominal) cycles it makes in ten seconds. After that we set it by 6 to find the frequency. We then did the same deuce other time changing the grass of the bob to 200g and 500g. That was the mass test. Secondly we did the length test. To do this we measured a pull back out to 1 meter and with a 500g weight and the amplitude of 50 degrees timed it again for ten seconds then measureing it by six for the frequency.

over again we did this two more quantify shortening the length of the string to 70cm then 50cm. Finally we did the amplitude test. With the mass of 500g and the length of 50cm we time-tested the amplitude. Starting with the amplitude of 80 degrees we again timed the total of cycles in ten seconds. We did so two more times lowering the amplitude too 70 then follow up to 60 degrees. If you requirement to get a full essay, golf-club it on our website: BestEssayCheap.com

If you want to get a full essay, visit ! our page: cheap essay